You’ve done it. You’re ready to handle your home’s plumbing maintenance and repair. What perfect timing! You probably have tons of questions on how to start and what to do, but fear not, this article can help you. Listed below are some tips that will help you get started with your plumbing aspirations.
Before starting any plumbing project be sure to turn off the main water supply. Water damage can be one of the most expensive things to repair. To minimize damage turn the main water supply off as well as any shut off valves near where you are working. This will save a great deal of hardship later on.
To prevent your frozen pipes from bursting, leave the nearest faucet on to give the water a way to escape. This will relieve pressure and might prevent the pipe from bursting, preventing further damage.
If you have noisy pipes, you can cushion them with a rubber blanket or add additional anchor straps. Banging pipes are usually caused by loose pipes, water hammering to a stop as you turn it off, or hot water pipes shifting in their position. All of these problems can be solved by cushioning and anchoring the pipes.
Frozen and bursting pipes from harsh winter weather is a problem that no-one wants, so plan now to winterize your exterior faucets and pipes against freezing conditions. A simple way to accomplish this is to find the exterior water shut-off valve located inside your home (often located in the basement). Turn off the water valve to stop water flow, and then open up the outside faucets to drain out any water that has collected. Be sure to turn off the outside water faucets tightly after the water has drained out. Take in any hoses you may have outside so they don’t crack from the cold weather.
Find a better way to discard of cooking oil instead of pouring it down the drain where it can easily clog your pipes. Keep a coffee can or other metal container handy to pour grease into after cooking. Place the can in the freezer to harden the grease and when it’s full, discard it with the trash.
There are many ways to unclog a drain. You can try plunging it at first. If that doesn’t work try using a chemical agent from the store. Before you go and spend money at the store though, if you have baking soda and some vinegar handy, you can mix those together and pour them in the drain and try to plunge that but if all else fails they have stronger remedies at your local hardware store.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Now you should be much more prepared when it comes to plumbing. If you thought that you were ready before, well you should now be an expert! The tips that were given should have provided you some advice that can help you get started with maintaining and fixing your own plumbing.…
Your house starts with the foundation and ends with the roof. It is obvious that the home’s roof is the most important element of the home. Proper roof care is just as important. The information below will be of vital use to you.
It is very common for the gutters on your house to become clogged, so make sure you have them cleaned on a fairly regular basis. If you allow them to stay dirty, it will give rain a chance to build up and pool on top of your roof, which increases the chances of the roof becoming damaged.
Since replacing your roof can be one of the most expensive projects besides the cost of the home itself, make sure you know who you’re hiring. Avoid the temptation to hire a friend of a friend, or inexpensive “handymen.” Look for a licensed contractor who guarantees his work and comes with many good reviews and recommendations.
When hiring a roofing contractor, you should make sure that he/ she has the proper equipment. If they charge you for labor by the hour, but are doing your entire roof with a hammer instead of a compressed air nailer, you will end up paying much more than you should.
Whenever you narrow down your list of contractors, ask each one their provided warranties. The warranty should last at least three years. Keep in mind that a longer warranty is always better. You should have defective supplies covered and poor workmanship, too. Don’t forget to get copies of any warranty that you are offered.
Different states often have different requirements when it comes to roofing. You may need to have a permit or a bond if you want work to begin on your house. Get in touch with the building department in your area to ask them whether this applies to you or not.
Sometimes it can be hard to determine if you just need your roof fixed or if it needs to be replaced. This decision is usually made when you have a leak, storm damage or your roof is at least 15 years old. Have your roof inspected by your insurer and trust in their diagnosis.
After a thorough inspection and cleaning of the roof, it is imperative to patch and seal any problem areas. Make sure that the weather report shows nice weather, because sealing materials may take up to two days to completely cure. A sealant or other coating should be applied after the areas are cured.
If you are working on your own roof, you must always remember that safety comes first. Never try and climb your roof if it is raining or the weather is bad. For that matter, you should avoid getting on the roof if it is still wet after it has rained.
As long as you stay educated on the topic of roofing, you can be assured you are doing all you can to protect your roof. You can ignore some household problems, but none that pertain to your roof. Using these suggestions can help your roof stay in good condition to avoid problems later.…
Do you feel you know about furniture and what to buy? There are all kinds of options available in furnishings today. Do you feel competent to make good choices? Continue reading to gain great tips on how to make your furniture purchases.
When buying old items, check the underside of each piece. Sometimes, the furniture appears to exhibit quality and a great condition, but often this isn’t the case. Old furniture can sometimes be plagued by dry rot or rust.
When you arrange your furniture, make sure that you do not place it too close to any heat sources. This can damage the material and shorten the life of these items. You should avoid placing furniture near air conditioning units as well, because the extreme cold can have a damaging effect on the material.
You should try looking for furniture pieces that are being sold by a reputable store. This is because well-known stores tend to offer warranties on their furniture. If something goes wrong within a specific period of time, they will replace the pieces. Smaller stores are not usually able to afford these type of warranties.
When purchasing a new bed, make sure you lay down on it to find the perfect comfort level for you. Many times people who choose pillowtop mattresses find that the mattress is too soft once they get it home. To help you avoid this, lay down in the bed in the position that you sleep in to ensure it suits your comfort levels.
Really look at the legs of any furniture you are considering buying. Those legs need to not only support weight, they’ll also be in contact with your flooring. If they look like they’ll do damage to your floor due to the materials used (like metal), then you may want to opt for a different style.
When buying new furniture or used furniture, make sure all the drawers and cabinet doors work properly before purchasing. Make sure the cabinet doors close securely and open easily. Test all the drawers to ensure they pull out correctly and close properly. If there is anything that is not working, get it fixed before buying.
The price of furniture can vary a lot from one month to the next. You can usually get some excellent prices if you buy your furniture around the fourth of July or Christmas. Shopping on Memorial Day or on Veterans Day is a good way to find deals too.
Look for pieces of furniture that are built solidly. Chests and dressers need to be made of wood that’s solid instead of wood that’s pressed. The back should be made of plywood instead of that cheap composite or cardboard. You can also test it by applying pressure to each side to see if it feels solid.
The advice given here will make your furniture purchase decisions more sound. Remember these tips to make sure that you’re getting the best deals. Furniture represents a large investment, and you should be proud of what you buy.…