Many people like to work with wood. With woodworking, you can create both practical and artful items. But to be successful, you really need to know your stuff. Learn all you can from reading this article in full.
Reusable sanding blocks save you time and money. To make them all you need is a few pieces of scrap lumber. Cut a piece of 2×4 into a rectangle approximately 2 inches wide and 4 inches long. Cut a piece of sandpaper the size of your block. Then, spray one side of the piece of lumber with spray adhesive and adhere the sandpaper to the block of wood.
If you will be re-coating an existing finish, be sure that the surface is clean and free of any wax or oils. Then, let it dry completely, and lightly scuff the surface with a 220-grit sandpaper so that the finish you are applying will have something to hold onto.
If you’re looking for that first woodworking project, how about starting with a simple box? In fact, that’s probably the most popular first woodworking project out there. Buy some cheap wood that you like, and design a box that could work around your home. Maybe it’s for writing utensils, or perhaps it’s for the kitchen? There are a lot of options.
Learn how to find the center in a piece of firewood every time. Mount some flat scrap wood to the lathe’s faceplate. Attach an acrylic piece to it using some double-faced tape. Chuck that in your lathe. Turn your acrylic to a disc. Using a 1/16″ bit in your tail stock chuck, drill a hole through that center-point. Scribe some concentric circles on to the disc at 1/2″³ intervals using a skew chisel. Position this center-finder over the end of your stock and adjust it until one of your circles is inscribed completely in a portion of the wood that is solid and usable. Using an awl or nail set, mark your center through the central hole in the disc.
Keep your work area as clean as possible. Woodworking creates a lot of mess, especially dust. This dust can get into your home and eventually into your lungs. This can cause real health problems down the road for you and your family. So take a few minutes after a job, and sweep up your space.
Sanding blocks are essential woodworking tools. You can create easy to reuse sanding blocks of your very own by simply cutting three-quarter-inch scrap lumber into rectangles measuring 4.75 x 4.50 inches. Cut pieces of cork tile to fit each block. Spray both the rectangle of wood and the rectangle of cork tile with adhesive and press them together. Allow to dry, then spray the backside of an entire sheet of sandpaper with adhesive. Place your newly made block on the sandpaper with the cork on the down-side. Allow to dry and then use a utility knife to cut the sandpaper around each block.
Most people cannot look at a piece of wood and imagine all the different things that can be produced from it. If you can, this article is for you. Have fun with woodworking and apply the advice in this piece.